Dating guild amps dating a man with ptsd
[Oct 2002] US 0 used; one can be bought for under [US] 0 - a total bargain US 0 [used], needed a little work but playable, cheap buy US 9 used, you can get one cheaper CAD 0 [used], good condition, seen at Songbird Music, Ottawa, November 1998 (since January 1999 though, it had changed its condition to 'very good') Rating very good amp My personal opinion is that the YBA-1 is better for guitar, while the YBA-1A is preferable for bass.My YBA-1A [...] uses 6550s and it's the best rock bass head that I've owned.
(Aaron, Craig, Dan Kukkonen, Dan Lear, Eric Knudsen, Greg, Jay Rogers, John, Jon Aley, Kraig Olmstead, Laws from Lawsstudio Canada, Moon Keith, Tim Baier, viva Analog at bc.ca/~jc, Features volume and tone controls only; it has two inputs, seems to be high and low, no major difference Two 6V6 power tubes This one is a '67 [amp] and is in amazing shape. ) speaker that looks identical to the 15" Jenson in my '64 Fender Vibroverb.
A YBA-1 has a nominal 8 ohm output, and the two speaker jacks are wired in parallel.
Runs on less than 440 volts, weighs 39 pounds Dimensions: 8"x18"x10" (HWD); weight: 40 lbs. (source: Catalog) Silvery grey grille cloth; Original layout was very close to the tweed Bassman and the Marshall JTM-45 50-watt models; noticably huge big heavy transformers are a Traynor hallmark in these units up till the approximately 1972 models; Early models were tube rectified (5AR4) and used two 7027A power tubes.
A 1967 YBA-1 is reported to feature a diode rectifier.
The used tubes are, as indicated in the amp: Two 6CA7s (replaceable by EL34s) and three 12AX7As (also called 7025s or ECC83s); plate voltages have always been a question on these units, but I think this may be largely because of confusion with the YBA-1A models that run VERY high plate voltages; most of the YBA-1 models probably come in somewhere /-450 volts (one has reported 425 volts on plate, another one ca.